| ||
|
You are logged in as a guest. ( logon | register ) |
FMC #850 | ||
Author: dkarnath (Show all albums) |
| |||||
Fried wire | This is the single power wire coming out of the wall above the bathroom window that was powering ALL the bathroom. Its sandwiched between the aluminum skin ceiling, and the spray foam wall. | I am looking for the reason I lost all power to bathroom. Here is all the fixtures (3 lights) and bath fan tied together.. | These are manual on/off 20amp 110v switched thermostats.... | ||
Finally got around to wiring in my new AC thermostats....I wasn't sure which avenue I was going to take (a year ago) for powering the AC compressor's, so I ran 4000' of romex just in case I decided to install exterior closet mounted thermostats. I would like to install a roof top unit in the future, but for now these will work for my rare use of air conditioning. | (1 Comments) Started on my transit conversion this morning... | I had to take the cut off wheel and trim the upper fiberglass a 1/4" in order to "smoothly" slide the furnace back into 850. I had to do the same with the AC units on the other side...I used a piece of masking tape for a guide. | |||
(2 Comments) Pulled the furnace out and bench tested it, worked great. Cleaned it up and will be reinstalling soon.... | (2 Comments) Crayon art with the two year old last night....She's a cool kid | (1 Comments) Here's my voltage reading AT the engine battery with everything warm, both front 12v heat and rear 12v heat running full blast, and the head lights on. Just a bump over 13v. I'd call this a happy charging system. | |||
|
Running MegaBBS ASP Forum Software © 2002-2024 PD9 Software | (Delete all cookies set by this site) | |