Search | Statistics | User Listing | Member Roster | Coach DB Forums | Albums
FMC Owner's Forum
Home -> FMC Owner's Forum -> Albums -> View Album

You are logged in as a guest. ( logon | register )

#477 Electrical system
Author: Duramaxer (Show all albums)

Show Newest Photos First | Show Oldest Photos First46 Photos - Page : [1] [2] [3] [4]


(3 Comments)
"New" window washer and viper setup. New washer tank and pump like the old one. New double nozzels and modyfied wiper arms to take "modern" wipers. Motors are fine, one was changed back in Illinois.


Good thing I stripped the whole unit. This picture is taken looking down the bottom part and it is like a tray collecting the condense water from the ac, and there is two outlets. Close to one of the two outlets there is a hole from rust and this would make the condes water leak out on the floor inside the coach. That would be a very bad thing so I will weld, sanblast and have it coated with some epoxy paint.


After picture was taken i cleaned up both cores and glued on some new Armalflex insulation to the heater core. The ac core had rubber on the sides and this could be reused.


This is the heater core. There is some foam ment to prevent ais from blowing down the outside of the core.


Had to take a look at the ac/heater unit while having it out of the coach. Quite a nice unit to work on. The blowers tested ok, just needed a clean up.


(1 Comments)
Added some flexible tubing for routing wires. This will make it better to work on the el after the insulation and fiberglass front is put back on. The orange tube is for the main harness, a couple of smaller ones for lights, signal horn and washer pump and also one tube for the gearshift cable.


(2 Comments)
And some of that same liquid thermal and aqustic insulation as used in the bedroom. This is after the first coating.I will go with three layers of this. I think it's quite simular to the "Lizardskin" that I have seen advertised over there. If I where to start all over I would have done the whole inside of the coach.


The ThermoKing is taken out. Cleaned up ready to put in new sealant everywhere.


Spaghetti


(2 Comments)
This is how thing look like behind the front. Window washer pump and tank is missing.


This is the damage I have been talking about. I feared it was more but this is quite easy to fix and I belive this is the last spot of bad rust on the coach.More on this in the other gallery.


The front had to come off again to repair rust damage to structure in left lower front corner. Now was a good time to do it as I needed to be able to reach all the wiring. In this picture the old foam insulation is removed.
Show Newest Photos First | Show Oldest Photos First46 Photos - Page : [1] [2] [3] [4]

Return to viewing all photo albums



Go to FMCowners.com HomeRunning MegaBBS ASP Forum Software
© 2002-2024 PD9 Software
(Delete all cookies set by this site)