Search | Statistics | User Listing | Member Roster | Coach DB Forums | Albums

Home -> FMC Owner's Forum -> Albums -> View Album

You are logged in as a guest. ( logon | register )

LCAC_Man #1027 LBZ Duramax Conversion

Author: LCAC_Man (Show all albums) This album will cover the Duramax/Allison conversion(including dash cluster integration), installation of airbags to assist suspension, conversion of vacuum brakes to Hydroboost, replacement of Onan gas generator with a Onan/Cummins 5500LP, inverter/charger installation, dual roof a/c installation, and Bedroom reconfiguration that will add "pass-thru" storage.

Show Newest Photos First | Show Oldest Photos First 461 Photos - Page : [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [16] [17] [18] [19] [20] [21] [22] [23] [24] [25] [26] [27] [28] [29] [30] [31] [32] [33] [34] [35] [36] [37] [38] [39]
(5 Comments) New KIB Micro Monitor panel, easy to get to and provides a second water pump switch between the kitchen and bathroom	during the installation of my new tank level panel I was testing some of the house power circuits, this is what is left of the bathroom lighting harness..	(2 Comments) I used some 2x2 aluminum angle as a mount and to provide some protection to the drain tube.	Fresh water tank work completed, I now have a proper drain in the bottom(not the side) of the tank. You can see in the foreground the section of the belly pan is cut away right below the doorway. I'm going to attempt to recess the power step assy to keep the ground clearance as high as possible.
Vertical crack, plastic weld repair. Tanks are fully filled and have been for 3 days without a drip, so I'm claiming victory. Only $100 to replace all three fittings, weld repair the crack and install two patches in the wheel well area where some misguided fool shot steel rivets in it and covered it with sealant..	New rear outlet (to the lower tank) fitting.	My local plastics shop (MGM Plastics, San Marcos, CA.) was able to repair my upper water storage tank. This is the new forward inlet fitting.	(3 Comments) figured I might as well do some good, cleaned up the floor panel and put down some POR-15. Got a couple spots where the carpet glue needed to be cleaned better so I'll acetone wipe and touch those in tomorrow
And then there's a 3" long vertical crack on the forward side of the tank.	All three of the 1 1/4" fittings are split just like this.	the small upper vent fitting is the only one that isn't cracked..	not an "off the shelf" tank..
Show Newest Photos First | Show Oldest Photos First 461 Photos - Page : [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [16] [17] [18] [19] [20] [21] [22] [23] [24] [25] [26] [27] [28] [29] [30] [31] [32] [33] [34] [35] [36] [37] [38] [39]

Return to viewing all photo albums

	Running MegaBBS ASP Forum Software © 2002-2024 PD9 Software	(Delete all cookies set by this site)