This is a view of the switch that I placed to the left of the oven location for the new exhaust fan switch which will be activated in connection with installing the new oven. Below the switch and on the underside of the cabinet you can see the new 12 volt power outlet. This will allow the recharging of 12 volt things somewhere other than the dashboard or the bedroom. | 
Here is the new water pump switch on the face of the cabinet above and to the left of the sink area. Very convenient when needing water when at the sink. | 
Here is the inside view of the area to the rear of where the oven normally is located. You can see the black positive wire that comes up from the six position fuse block I earlier installed on the floor under the counter (see Correcting Voltage Drop album). That wire brings power to the stud on the back of the 12V outlet. Then, since that is an intermitant use, I added wires to two other intermitant uses. The red wire goes to the air horn solenoid and the green wire to the new water pump switch on the other side of the stove opening. Note: the green wire from the air horn solenoid goes to the horn selector switch and then to the horn button on the steering wheel. | |
