|
|
Elite Veteran
 
Location: Medford, OR | Hey Lou,
Is this a special/specific size bushing driver in your pic? Or just a random piece of steel? I'm about to do this job and was curious if I will be able to pop the new bushings in/out without the use of any special tool.
Thanks
http://www.fmcowners.com/mbbs22/photos/show-album.asp?albumid=148&p...
|
|
| |
|
Extreme Veteran
Location: Scottsdale, Aridzona | Hey Dan,
I've got a 14 X 30 Taiwan lathe and a Bridgeport Mill . . . so turned some steel bar stock . . . filed to fit . . . and paint to match.
Hard to get a good "step" shoulder on a round "driver" without a lathe.
I'll provide dimensions . . . if you have a friend or a shop that can whittle them for you from a good piece of steel . . . no regurgitated rebar.
Drive OUT ! Lou #120 |
|
| |
|
Extreme Veteran
Location: Scottsdale, Aridzona | . . . and please see - http://www.fmcowners.com/mbbs22/forums/thread-view.asp?tid=781&post...
and my Message #4034 about using the "tools" in the pictures in the link above. Lou #120 |
|
| |
Bell Crank Bushings
