|
|
Veteran
 
Location: Houston, Texas | Thinking about changing the brake rubber hoses on all 4 corners
and maybe connecting them on the lower wheel cylinders, anybody has
some part numbers for them ? suggestions ?? opinions ??? or ???
Flushing the entire system and trying to get all the air out with a pressure bleeder
and was thinking about changing the hoses, they look like they maybe the original ones,
bleeder works great on the small master cylinder..
https://www.speedibleed.com/products/brake-bleeding-kit-diy/k300b-do...
Rico & Carmen
397
|
|
| |
|
Elite Veteran
Location: Oceanside, CA | http://www.fmcowners.com/mbbs22/photos/photo-thumbnails.asp?albumid...
and
http://www.fmcowners.com/mbbs22/forums/thread-view.asp?tid=797&post...
Edited by LCAC_Man 2018-03-07 4:16 PM
|
|
| |
|
Veteran
Location: Houston, Texas | is there any part numbers for these hoses or did you just order them custom made ?
I'm getting ready for these hoses and would like to order them or get them made
here in Houston ?? (if I'm lucky)
Thanks
|
|
| |
|
Veteran
Location: Houston, Texas | found these hoses part number, I think these will fit front or back ????
Brake Hydraulic Hose Dorman H31669 fits 60-66 Ford F-250
the local part store order 2 for me, they look the same as the two
old front hoses I removed from the front....
Rico |
|
| |
|
Elite Veteran
Location: Oceanside, CA | At over 24" they will be really long for the front, they may (depending on how/where your rear brake hard-lines are plumbed) be good for the rear if you plan to use the lower cylinder connection...my rears were 26" so it will be close.. |
|
| |
Brake Hose Part Numbers ??
