|
|
Elite Veteran
  
Location: Victoria, BC. Canada | Can't say I've seen these before.
Check out the last pic in the series here:
https://seattle.craigslist.org/skc/cto/d/seattle-1973-fmc-motorhome-...
Anyone who knows what they are (part #) please share it.
I emailed the seller to try to get more info.
Perhaps another option for Alcoa's that I (we) weren't aware of?
Terry
#846 |
|
| |
|
Extreme Veteran
Location: Scottsdale, Aridzona | http://www.fmcowners.com/mbbs22/photos/photo-thumbnails.asp?albumid...
|
|
| |
|
Elite Veteran
Location: Oceanside, CA | If you can find those 10 on 7.25 wheels for a good price it's definitely and option...or just have these done the way you want to start with: https://alu-wheels.com/A196009-BBM19point5inchx6inch_NO_PCD_BLANK
|
|
| |
|
Elite Veteran
Location: Medford, OR | That's my old FMC #850, it's a 1975, get the year right for that money.... |
|
| |
|
Elite Veteran
Location: Medford, OR | http://www.fmcowners.com/mbbs22/photos/photo-thumbnails.asp?albumid...
|
|
| |
|
Elite Veteran
Location: Victoria, BC. Canada | Sorry Dan-O!
My bad. Should have recognized the old girl right away. Especially with those low seat backs because I distinctly remember our discussion about raising them up some.
Terry
#846 |
|
| |
|
Regular
| Who and where could you find to machine the wheels Len? Looks a lot better than spending nearly $600 for a well used wheel. I don't have the equiptment or ability to do this myself.
Thanks, Hal |
|
| |
|
Elite Veteran
Location: Oceanside, CA | Hal,
The same company that sells them will put any pattern on them you want. I think when I asked them it was $100 a wheel to custom machine, but, that's been a couple years back when I was looking at 22.5" blanks with the 5 lug pattern..
|
|
| |
10-hole 19.5" Alcoas?
