Search | Statistics | User Listing | Member Roster | Coach DB Forums | Albums
FMC Owner's Forum
Home -> FMC Owner's Forum ->  General Discussion -> Trader's Market -> View Thread

You are logged in as a guest. ( logon | register )

Completing #1027 Paint and Parts Needed...
Jump to page : 1
Now viewing page 1 [25 messages per page]
View previous thread :: View next thread
   General Discussion -> Trader's MarketMessage format
 
TravalonSF
Posted 2021-04-21 5:37 PM (#7708)
Subject: Completing #1027 Paint and Parts Needed...


Contributor

25
Location: San Rafael, CA
Hi Gang,

Now I know why the estimates for painting 1027 were from $25k to $35k in California. No it's not the EPA or OHSA... it's simply a lot of damn work!!! I'll upload photos this week.

Anyone have a resource for the black plastic trim covering the rivets in the window frames?

Driver's Door and Side Door rubber seal? Thanks for the help or suggestions.

Also, I'm still looking for the pieces below:

Passenger side window with slider at bottom

4 black handles for the interior cabinet doors

Plastic cabinet drawer latch in good shape found just below the sink

Original style window blinds in good condition

Interior light switches in good working order (black toggle type)

Driver's side air vent in good condition
Top of the page Bottom of the page
andy1canada
Posted 2021-04-21 10:44 PM (#7709 - in reply to #7708)
Subject: RE: Completing #1027 Paint and Parts Needed...


Elite Veteran

500100
Location: Victoria, BC. Canada
Hey,
Can't wait to see the paint work. Wow, that's a chunk-a-change dude!

After my engine swap is done I'm going to have at mine with the HVLP (4-stage turbine) spray system I scored for $200.00.

I'll use it to lay down the white base coats then decide if I'll do the other stripes/graphics, or, hire someone.

Figure I may as well have a whack at it as I've tackled most other work myself.

On the window blinds: I went with 1" aluminum mini-blinds (in natural aluminum finish) and I couldn't be happier. Got the whole works from Home Depot for just over $300/CAD.

Got them all cut to size for every window but the two forward triangles and windshield. Also made my own wrap-around curtain for those.

Hopefully others chime-in on the other stuff for you.

Good luck!
Terry
#846
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

Go to FMCowners.com HomeRunning MegaBBS ASP Forum Software
© 2002-2021 PD9 Software
(Delete all cookies set by this site)