|
|
Regular
| Looking for the recomended torque for Alcoa wheels. My search of the Forum didn't find any results though I'm sure it's certainly 'operator error'. Thanks for any advise.
Hal |
|
| |
|
Expert
 
Location: Cottage Grove, OR | Mine are at 400’#. |
|
| |
|
Extreme Veteran
Location: Scottsdale, Aridzona | Pg 39 - https://www.alcoawheels.com/alcoawheels/catalog/pdf/2017_service_man...
How are you going to get them that tight ?
How are you going to get them loose ?
Lou #120 |
|
| |
|
Regular
| Thanks for the link. 450-500 ft lbs looks like the number I was looking for. I use a 3/4" Makita 115 volt impact just for the wheels. It's rated 500 clockwise, 550 counter clockwise. Use it on our Eagle bus for wheel work. At home I can always drag out the 1" IR gun with a 1/2" hose. I run the compressor at 175 lbs so it'll make quick work of most stubborn fasteners. Bit of a man killer though, guess I'm getting old.
Thank you again, Hal |
|
| |
|
Elite Veteran
Location: Victoria, BC. Canada | Agreed. These days cordless impact guns are going off the chart with what you can do with them.
Example: https://www.milwaukeetool.com/Products/Power-Tools/Fastening/Impact-...
Real happy with mine.
Terry
#846 |
|
| |
Alcoa wheel torque
