|
|
Expert
Location: Cottage Grove, OR | Does anyone have the part numbers for the U joints in the drive axels. Right now the part number for the outer u joint is needed but would like to have both referenced in this thread.
Thank you, |
|
|
|
Elite Veteran
Location: Victoria, BC. Canada | borg Warner 114-7207(trans to diff) and borg Warner 114-7205 (prop shaft to wheel)
IIRC: Billy sent me these recently.
I'm doing mine soon, too.
Terry
#846
|
|
|
|
Expert
Location: Cottage Grove, OR | andy1canada - 2020-08-18 5:51 PM borg Warner 114-7207(trans to diff) and borg Warner 114-7205 (prop shaft to wheel) IIRC: Billy sent me these recently. I'm doing mine soon, too. Terry #846
Terry, did you mean differential to the axel for the first number? |
|
|
|
Elite Veteran
Location: Victoria, BC. Canada | I just went through my email archives to try to confirm if in fact it was Billy that sent me this info. Can't find anything so now I'm wondering if I got them off the forum or something.
Hopefully someone will chime in here. Didn't Dan just do his?
I think I sent my self the email description above as a quick reference for myself. I think it means: the first number is for the driveshaft U-joints (input) and the second is for the prop-shafts (output). That said, didn't I just read recently on one of Dans posts that the two U-joints in the prop shafts are different?
Again, hope someone chimes in here as I'm now some confused.
Terry
#846 |
|
|
|
Extreme Veteran
Location: Ignacio Colorado | 05 is differential end of side axle. 07 is outer wheel end. Not input driveshaft from transmission.
Bill |
|
|
|
Elite Veteran
Location: Victoria, BC. Canada | Figures I'd screw it up somehow.
Thanks for clarifying Billy!
Terry
#846 |
|
|
|
Expert
Location: Cottage Grove, OR | Thank you everyone. The driveline shop in Eugene had two of them in stock. |
|
|
|
Elite Veteran
Location: Medford, OR | No Terry, I chimed in recently on differential output yoke grease seals, and I just did a stub axle job. My u-joints still look to be good. I will be referring to this thread though Im sure when I do need to buy u-joints....Im about to search tie rod end numbers.....Stephen? |
|
|
|
Expert
Location: Cottage Grove, OR | Dan, I have a set in the parts shed. I will take a picture and send to you. |
|
|
|
Extreme Veteran
Location: Ignacio Colorado | Moog ES373R and ES373L are the tie rod ends.
Bill |
|
|